Steps of How to Install Hardwood Stairs with Railing
How to install hardwood stairs with railing – It is not necessary to call the contractors for this simple approach do it yourself to finish a ladder. For safety and aesthetics, it is smart to finish your staircase with a sturdy wooden handrail. Few inputs and building know-how will found on your way to completing the task. Starting with install the handrail by joining two 4-by-4 posts at the top and bottom of the stairs.
Place them against the stringer of the ladder, the creation part of the climb of the stairs from creations of how to install hardwood stairs with railing. Hold a set of tweezers in place and secure with hex bolts. Check with a level to make sure they are flush with the wood of the spar and perpendicular to the floor. Measure and mark messages at 34 inches in height from the bottom. It will cut the posts later. Of these marks, Measure down 6 inches and marks the messages. Practical positions on the 34-inch mark you made cut at a 45-degree angle down.
Cut three pieces of handrail that matches the length of the entire staircase from post to post. Fix one of the three pieces as the handrail “lid” on top of the two entrances using hammer and nails. Hammer a piece of second handrail just below the top of the handrail to the outer sides of the posts. Attach a third piece of rail to the 6-inch marks with nails. Trim the edges of all the pieces of the handrail so they are straight. Sand the edges of the handrail until soft. And the steps for how to install hardwood stairs with railing were done.